25% OFF!!! Buy Lockable Cat Flap Dog Door Manual Control Access Pet Door 4 Way Locking CAt Door White for Puppy Pet Cats only US $13.92.
Lockable Cat Flap Dog Door Manual Control Access Pet Door 4 Way Locking CAt Door White for Puppy Pet Cats
|Rating||5 of 5.0|
|Seller||smalllee lucky store Official Store|
Returns accepted if product not as described, buyer pays return shipping fee; or keep the product & agree refund with seller.
On-time Delivery: Full Refund if product isn't received in delivery time estimated
|Brand Name||:||smalllee lucky store|
|Type||:||Standard Cat Door,Standard Dog Door|
|Dog Size||:||It fit for small animals, like puppy cat small dog up to 7kg|
|Closure Type||:||Pull On|
|Theme||:||Lockable cat flap|
Lockable Cat Flap size details:
For cats up to 7kg
Maximum shoulder width 150mm, for use in solid wooden doors quick and easy fit.
Complete with fitting screws, magnetic flap keeps door closed when not in use.
Total size of unit Height:22cm/8.6inch * Width:20.2cm/7.9inch
Cut out hole size Height:15.5cm/6.0inch * Width:15.5cm/6.0inch
1. Measure the height from the ground to the lowest part of the cats chest and make a horizontal mark on the door at the correct height.
2. Using a ruler, draw a horizontal line 155mm long at the same level as the previous mark.
3 Using a ruler, draw a vertical line 150mm long at each end of the horizontal line at a 90 degree angle. Finish by drawing the top horizontal line and completing the rectangle.
4.Using a drill, make a hole on the inside of each corner. Then, using a jigsaw, cut out the rectangle following the lines.
5. Sand the rough edges down to make them smooth.
6. Place the cat flap over the hole and mark the position of the screw holes. Drill pilot holes for the screws, position the cat flap into place ensuring the lock is on the inside of the door and tighten the screws using a screwdriver.
If you think the cat door thickness is too large, it can be cut. If your house door is too thick, you will need to change to the long screws for it fixed. This cat door fit for all the common door categories, the most important part is to make sure in advance whether it is ok to dig holes, drilling and other steps when install in your home door!
Cat doors Installation:
Tools required: electric drill, saw or chainsaw iron, measured with a ruler.
1: Firstly draw a outside size of cat door cover with a piece of paper (there may be a few millimeters error).
2: According to the painting paper lines and drawing on the door with a pencil.
3: Use a drill to drill a hole in the four corners of painting through a door,if there is a chainsaw,then begin to dig the hole directly.
4: If it is a glass home door, need gently cut with a glass scribing tool,and use glass glue fixed.
5: Cave Amoy Well, now use a smooth wrapping paper or kraft paper to wrap around the hole, for aesthetics.(You can also use others artwork to decorate around the cat door)
6: The cat door placement, there are accessories screws,use a screwdriver to tighten.
7: Screw port comes with screw cap, press on, OK, finished.